Install the rotary attachment on xTool D1ġ. Click Frame to see whether the pattern is to be engraved in the expected position of the material. Draw a square on the canvas on LightBurn.ĥ. You can move the laser head to place the center point in the position where you want to start engraving.Ģ. The center point of the cross-shaped light beams is the start point for framing. Put down the focal length setting bar to set the height of the laser head. Place a material to be engraved in the working area. The following device information is displayed after the file is successfully imported.ġ. Click Import to import the file xTool_D1_Prefs.ģ. If you choose Import Prefs, the original configuration is overridden.Ģ. Make sure that you start to configure xTool D1 in this way instead of choosing Import Prefs from the menu. Open LightBurn, click Devices on the Laser Note: Make sure you use the latest version of LightBurn.īefore you configure xTool D1, download the configuration file first:ġ. If you are a new user, you have a 30-day free trial. Go to to download the latest version of LightBurn, and install it. If errors occur due to incompatibility, you can contact our after-sales service for technical support. The firmware of xTool D1 has been tested in detail by Makeblock Co., Ltd, but incompatibility with the software or hardware may still occur. shall bear no responsibility for any loss caused due to the operation of LightBurn. LightBurn is third-party software, and therefore Makeblock Co., Ltd.

If you need to control xTool D1 through LightBurn, download the official release of the LightBurn software.

Lightburn software cost